Messing around with my 2016 RC this morning I found out I need to replace my clutch cable. It was about to break at the lever. Now, I did remove the cable and thought I would try moving the clutch lever on the engine and put it in gear to see what would happen and it kills it every time I put it...
So I was cleaning my chain today and ask went well until at the end when I decided to turn my bike on while it was on the rear stand. I had it in first gear with the clutch pulled all the way, and then I notice the rear wheel is spinning. I adjust my lever all the way out so I'm pulling the...
Can someone take a picture of their clutch cable down where it attaches to the engine? I didn't take a picture and want to know which way to orient my spring. Thanks.
Hey guys,
I managed to strip the throttle cable threading on the bottom of the engine start switchgear box. I was trying to tighten down the lock nut and ended up backing out the cable housing.
Any ideas here? I'm tempted to just epoxy the elbow joint into the switchgear. There is a still a...
Hello Everyone.
i've never dealt with a motorcycle clutch before, so i thought i would pick some brains here before taking things apart.
i started feeling looser play in the clutch while at the track yesterday, and it kept getting worse. it basically felt like there was less and less...
I know its a little early to be asking this question, but I figured I'd get the gears turning.
With the 2017 RC390 being ride by wire, will a quick throw throttle be possible? If not, do you think it would be possible to retro fit the throttle system to the cable setup? I'm not talking about an...
Hi fellow riders,
I might be needing a new clutch kit. Please advise me on where to buy the OEM parts for my 2015 RC 390 (not slipper clutch).
The story: Only after a few thousand miles my clutch starts slipping at high revs. I tried adjusting the cable at the lever and engine however I...
Would a snapped throttle cable be covered under warranty? Is it worth the effort taking it to the dealership? The parts less than 30 bucks, how difficult of a job is this? I'm a master auto tech but something about working on my own bike kinda irks me considering how hairy sh*t could get if i...
Howdy there,
I am a new rider (the RC 390 is my second bike; first was stolen shortly after purchase) and I just had my first wreck last week after about 7k miles on my 390. I posted about this on /r/motorcycles, but I'd like to ask you guys about some repairs.
Here is a picture of the crash...
Got the grips a few days ago and picked up the levers today. With these grips my right hand no longer bothers me. The levers sure look good and the levers adjust them with a satisfying click but curiously for me I like them as wide/far from the grips as they go. The rubber thing on the end of...
I built an OBD2 connector based off the excellent info from this forum: https://gearheads.in/showthread.php?24542-Indian-KTM-Dukes-Building-an-OBD2-Cable-for-Datalogging-the-DUKE-200-390-amp-RC-200-390-CODE-6-Tuning
The connector is a Sumitomo HM 090 6 Pin Male: Motorcycle .090 - Connector and...