I am selling a brand new Power Commander as well as DNA filter and MNNTHBX airbox lid. All items are new, never used. The Power Commander comes with the oxygen sensor which is no longer available.
Power Commander is for a 2015 KTM RC 390.
Items all together go for 553 before tax and shipping...
I love the job HardRacing did with this kit. The videos, the closed loop tuning, this is really a must have for any Power Commander owner. That being said, the fuse taps you guys supply could use a little work. I just installed one of these...
I no longer have the bike. So its been sitting there for a while. I used the power commander for about 4k miles.
Asking for 200 or any reasonable offer.
it has a map on it for the werkes exhaust, K&N air filter, and the airbox mod.
let me know if you're interested.
[email protected]
Hey all, I recently purchased a set of Tyga oval undertail exhausts for my 2016 RC390 from Formula390. The bike already has a PC V installed from the Werks exhaust I'm replacing (jesus that thing was loud) and I'd like to adjust the tune to match. Searching high and low for a baseline map for...
.
It's been quite a while, but it's finally done.
Dyno Jet Released the 18-023 to fit the '17-'18 RC390 & 390 Duke ... which have ride-by-wire.
Click here to order >> PCV 18-023 <<
Less than a year old. Just over 5k on the odometer to date. Bought brand new in Nov 2015. Original owner
Upgrades:
Fender eliminator
LED headlights (6k)
Power commander - tuned by Hard Racing
Powerparts adjustable levers
BNC street air filter
MAKE ME AN OFFER - CLEAN TITLE IN HAND...
So as I am sure most of you are aware of my bike issue that took place seconds after I had installed a power commander from commonwealth. If not I will refresh, immediately upon turning on the key the engine light began to flash. Upon startup the cooling fan turned on full speed and no temp was...
I installed my power commander today and have two questions.
1. Item 15 in the instructions says to unplug the stock crank position sensor, it's a black 4 pin connector near the FRT, LH side of cylinder head. Picture in instructions shows a 6 pin and a 4 pin connector. I could not find a...
Just want to get more information on the Power Commander, Are there anybody using it for their bikes? Just wondering if it's a necessary upgrade. Already got the new yoshi exhaust and K&N air filter. Thanks!
.
So now that the PCV is installed. it was time to install the Dyno Jet Wideband Commander 2 ( WBC2 or WB2) p.n. 15-7023x........ so we could have more Control over the Fuel map on the bike.
As many of you know the KTM 390 has a difficult ECU that doesn't allow closed loop to be altered...
a/f
autotune
band
bike
closed
commander
conjunction
control
ecu
fuel
ktm 390 wb2 installation
loop
low
map
output
pcv
power
ratio
sensor
voltage
wb2
wbc2
wide
wideband
wire
My PVC will be in the mail tomorrow, I only saw 2 tunes on Dynojet's webpage. Is there anyplace to start with tuning this thing?? Just new to the power commander .. thanks