The fuse 7, which is instrument cluster/control unit fuse (10A) keep blowing off. I disconnected the instrument cluster and the fuse still blew. I checked OBD codes and it has a P0108 code, which is "Manifold Absolute Pressure/Barometric Pressure Circuit High Input"; not sure if it is related to...
I love the job HardRacing did with this kit. The videos, the closed loop tuning, this is really a must have for any Power Commander owner. That being said, the fuse taps you guys supply could use a little work. I just installed one of these...
My check engine light is on after the fuel pump and ignition fuse was tripped. The fuse is replaced and everything is running fine but the engine light is still on. How can I reset the computer to make the fault clear and turn off the engine light.
i recently went to track and during my prep, i pulled fuse #6 so i wouldn't need to tape up my lights. However when I went to try to start my bike, it wouldn't start. ideas on why? I'd prefer to just pull my fuse so i don't need to tape.
thanks
Hey all. So here's the skinny. My frustration is beyond maxed out and I need help. I have a 2016 RC390 with just about 3K miles. It is a track only set up. The water pump gasket went out about two months ago and I got it fixed at the dealer under warranty. I took the bike to the track the...
FYI: your stop/turn/tail/horn fuse has some odd connection to your speedometer. Not sure why or how, but...
Story...
My speedometer was reporting very erratic readings during a track day this weekend - jumped around, read very low speeds when 6th gear WOT, etc. I had just completed the 600...