Rcdan
New Member
I have been wondering about this for a couple of months. If you have ever held the passing light switch on when riding you know how much better it is than just the single high beam. I also noticed one of our vendors sells an LED upgrade and plug and play harness to have both lights on for high beam.
My thought is why not just solder a jumper wire from the power in to the switch to the wire out to the low beams. This would power up the low beams whenever the lights were on but also allow the high beam to be switched normally. I was looking at the wiring diagram and the power out to low and high beams is separate so it will not back feed or cause any other problems that I can see.
I plan on doing this soon and will post picks and let everyone know how it turns out. Seems simple enough though.
My thought is why not just solder a jumper wire from the power in to the switch to the wire out to the low beams. This would power up the low beams whenever the lights were on but also allow the high beam to be switched normally. I was looking at the wiring diagram and the power out to low and high beams is separate so it will not back feed or cause any other problems that I can see.
I plan on doing this soon and will post picks and let everyone know how it turns out. Seems simple enough though.