slashfive
Member
'15 with stock exhaust, open airbox/KN filter, PCV
What do I want?
Thanks. Eric.
What do I want?
Thanks. Eric.
'15 with stock exhaust, open airbox/KN filter, PCV
What do I want?
Thanks. Eric.
Definitely no rev xtend enabled. It's a 2019 model. I did take a look at the dyno graph and it's pretty flat from 9880 - 10250rpm so that seems about in line with what you are sayingSomething isn't right there. Did you get Rev Xtend set up for the PCV? Peak should move to 10250 roughly.
Sentcan you send that chart to me? [email protected]
Pretty sure you'll need a map especially if you open the lid. I can't say much though because I did all my mods at once, slapped on a map and then rode over to a shop to get a proper dyno tune done the next day. Anything that is adding air will need added fuel to keep the air/mix right. Otherwise it'll run leaner, hotter and could burn your valvesinteresting! I have PCV on my 2020, I just asked in this forum about opening the box and someone on FB recommended the Gray Area AirBox. Do I need new map on the PCV to obtain the gain? Running Stock Exhaust, Stock intake at this moment.
Increase the rev limit to 11250 and it will need a map. I don't have one for that setup.interesting! I have PCV on my 2020, I just asked in this forum about opening the box and someone on FB recommended the Gray Area AirBox. Do I need new map on the PCV to obtain the gain? Running Stock Exhaust, Stock intake at this moment.
Hi are these still available pleaseKTM has finally released their HOMOLOGATED intake runner for the RC390! This little monster will typically net you a 20% gain in top end horsepower, right where you want it for race use! These modifications were all done with a closed air box lid. If running an open lid and performance exhaust system you will need an oversized injector, this thing turns the RC into a monster! If you do not have any rules to follow we offer the ones we make in house at a significant discount and you will get a whole airbox assembled and ready to install. All versions come with a map and instructions.
View attachment 4907
View attachment 4908
Homologated version:RC 390 R Air Tube
Non Homologated: RC 390 Intake Runner
Hello, do you have a complete set of RC390 power modification kits for sale? I want to modify the RC390 to the fastest state to raceKTM has finally released their HOMOLOGATED intake runner for the RC390! This little monster will typically net you a 20% gain in top end horsepower, right where you want it for race use! These modifications were all done with a closed air box lid. If running an open lid and performance exhaust system you will need an oversized injector, this thing turns the RC into a monster! If you do not have any rules to follow we offer the ones we make in house at a significant discount and you will get a whole airbox assembled and ready to install. All versions come with a map and instructions.
View attachment 4907
View attachment 4908
Homologated version:RC 390 R Air Tube
Non Homologated: RC 390 Intake Runner
Shoot me an email at [email protected]Hello, do you have a complete set of RC390 power modification kits for sale? I want to modify the RC390 to the fastest state to race