Recent content by captninja

  1. C

    Check Side Stand Bolts!

    While you are down there, check your shift lever. if it has any play, tighten it even if the bolt seams tight until there is no play. Mine was loose from the factory. The bolt will seem tight, but the fitting is not clamped tight enough on the shaft, Just tighten until all the play is gone. If...
  2. C

    Blink Code?

    Not really sure what you were trying to say, I'm just an (old) old time mechanic. Tried the 22k resister, did not work. I think the resistance is so high that the circuit is still open, or the ecu thinks it is. Wasted $1.50 at RadioShack. Measured the resistance of the solenoid at 15 ohms. Back...
  3. C

    Blink Code?

    Been there done that, does not work. 15 ohms eliminates the code.
  4. C

    Blink Code?

    You need to install a 15 ohm resister across the plug pins
  5. C

    Let's see your RC

    Bike weighs 335 lbs and I do a few track days with it. Haven't dynode it yet but probably will soon. Really curious to see what it puts out.
  6. C

    Let's see your RC

    It's a GPR Deeptone that is made for the Duke.
  7. C

    Let's see your RC

    Here are a few pics of mine
  8. C

    EVAP (emissions) solenoid\purge valve removal

    22k ohm resister is way too much. The solenoid only has 15 ohm resistance across the poles. I installed a 15 ohm resister in the plug, light's out.
  9. C

    EVAP (emissions) solenoid\purge valve removal

    The OHMS across the solenoid poles is 15Ohms. Installed resister across plug and light went out. 22K resistor way too much resistance.
  10. C

    Riders age?

    70 years old. Got my first bike at 50, still own it.
See more
Top