Recent content by rcrider

Was able to pick up this badboy for €450. Spring might be a bit light previous rider was 75kg total I'm 90 kg total. Does anyone know what springs would fit and where I would be able to get these?

it is however quite loud a the moment it is straight piped with dB killer this is the current de-car and pre muffler delete How much quieter would it be with a pipe that does have a cat?

here is a video and some pictures:

Got it tuned! Installed everything over the holiday and got it tuned last week it runs and feels amazing final figure was 47.6 HP at the rear wheel

Started installing all my parts today! Ended up going with the following setup: DNA high performance airfilter Gray area custom airbox Gray area bigger injector Rapid bike evo Cat+ pre muffler delete I was wondering about the following: On the stock airbox this hole is plugged should I...

I was scrolling through the Netherlands' main 2nd hand stuff website and found a seller offering 2 PCV for 225,- euros each. (not my ad) for the throttle cable models I have a throttle by wire model (2017) and already have a rapid bike EVO but if anyone is interested here is the link...

update..... I was cleaning up and put the coolant in a different container... It does not look as bad (don't use a blue bucket) Should be ok then if I reassemble the waterpump refill the system and keep an eye on the level This is a big fail on my part but also a big relief regarding not...

Back woth another update I opened up the waterpump and didn't see too much out of the ordinary seals seemed ok and the grease was still there. Ordered some replacement high viscous high heat etc grease before I install the new water kit. The turbine also looked fine no excessive where or...

Very sweet ride!

Received the first couple things in today!

Another question: Is it possible to run the high-compression gasket without any other internal engine upgrades (except the included head bolts)? Or should I just install an OEM head gasket?

Thanks for the tips @KTMLaos !! going to start with opening up the water pump I ordered a bunch of stuff today: Oil filter and strainer kit Waterpump seals kit Front Head Lift Paddock Stand V5 (already had a rear paddock stand) Motorbike Scissor Lift ConStands Mid-Lift M (for possibly dropping...

Drianed the bike of it's oil and coolant today first drained the oil it was definitely ready for a change I'm going to order a new filter set for it right away aswell. Put some paper towel in the filter housing and drained the coolant. Coolant definitely has oil in it, does someone know how I...

So.. a blown headgasket.. I was riding on the highway stopped to refuel and afterwards bike wouldn't start. Battery voltage was fine, starter motor was spinning but not engaging. Got it started and after 2 minutes check engine light came on. Got home riding over backroads not going over 70. When...

This is my first post! For the next track season I am considering upgrading my RC 390 by installing a free flow exhaust and a high flow air intake, completing the upgrade by installing a PCV and getting a custom map om the dyno. This is my current plan: Exhaust: -Install a cat delete pipe in...