On the rebuild a high compression gasket was installed and the valve clearances were set tight, .6 and .1, is this to get more out of the higher compression or do I need to correct this?
Pb blaster make a decent enough lube to get the correct torque value you think? I'm fixing to tear into mine and go over everything, got high compression gasket kit from gray area I'm going to use
Trying to save as much money as possible but I have looked at the tyga fairings. As well as hotbodies, and some ebay fiberglass kits.
I wouldn't mind if the paint wasn't so shifty
Here's the fenders after a round or two of stripper
Bike had been stolen, I'm rebuilding it
In need of fairings, whatever you dont see pictured
as well as seats, they're held in place by hopes and dreams after being broken into
I'm located in western NC
How's it going buddy. You still on here? I've just joined recently and have some questions about how you deleted the abs and kept the speedo, as well as what you used with the rc8 forks