EVAP (emissions) solenoid\purge valve removal

[big_sur]

So I removed all this emissions crap on my bike and it runs fine but it's throwing an FI code if I leave the solenoid unplugged and I'd prefer for that not to be the case. Does anyone know what kind of resistor needs to go in place of this purge valve\solenoid?

 

[cjwell]

Just have Akra map flashed in, it will kill it...

 

[Fasteddy]

Or stuff a 22k ohm resistor across the pins of the plug....

 

[big_sur]

Great, thanks guys

 

[RC390 Fan]

So did you remove the solenoid or just unplug it? If so what do you do with the hose, plug it?

 

[big_sur]

Removed it and plugged the port on the throttle body - see pic here: http://www.rc390-forum.com/forum/ktm-rc-390-general-discussion-forum/734-big_surs-race-build-2.html

 

[captninja]

Removed it and plugged the port on the throttle body - see pic here: http://www.rc390-forum.com/forum/ktm-rc-390-general-discussion-forum/734-big_surs-race-build-2.html

The OHMS across the solenoid poles is 15Ohms. Installed resister across plug and light went out. 22K resistor way too much resistance.

 

[captninja]

22k ohm resister is way too much. The solenoid only has 15 ohm resistance across the poles. I installed a 15 ohm resister in the plug, light's out.