Recent content by shreeshar7

The CAP.! Guys... I feel the problem is with the radiator pressure cap. Try replacing it and then bleed the system once. One of my friends had the issue where after a ride if I turned off the bike and again turned it on after a while..the temperature would skyrocket.. Also fans keep...

Could be a faulty side stand sensor/switch? Since u say it revs fine in neutral and happens at high revs in gear.! Also check if the spark plug adapter is fitting well and making good contact and check the HT coil plug too. If these dont sort anything, you might have to do a fuel pump...

Crank it over a few times. Smell the exhaust.. If it smells like petrol. Then its the spark. Try replugging the plug adapter and also the coupler that goes to the HT coil.

I had a very similar issue on the day I got my bike.. It ended up as a bad pickup coil.. It would ground once engine heated up..

So are you suspecting a bad CCT or the motor actually have low oil pressure? I'm not able to fix on one since the motor has had history of low oil pressure. Please suggest me on what to try replacing or check next?!

Will check that.. Do the 390s have. A hydraulic cct?

The engine was rebuilt 2 month back..the entire engine! It has done around 4000 kms.. There was a recurring low oil pressure issue for a long time which these guys couldn't rectify after repeated attempts.. Later it was found to be evacuation pump strainer twisted. They then replaced it...

The bike makes quite loud..ticking/clatter sound on startup..the noise stays for like 30 secs and then it runs normal.. Took in the bike to the dealer today..,they said it is tappet noise so they removed head cover,checked clearances, replaced one of the intake side shims, and exhaust side...

I had this issue earlier on my 2015 Rc390. Until the engine warms up if I slowly let go of clutch and slightly open the throttle it would stall. This would also happen in situations like slowing down at a speed braker and again using clutch in first or second gear with slight throttle...

Try running it stock without the PCV and check.

Check the evacuation pump stainer. Another drain bolt under the engine, facing front of the bike. Remove it once you drain oil from mail drain bolt and check how much oil u getting out of this, it could be twisted if not installed properly..check.

Heat soak is fine..but temps go almost to all bars.. Thid never used to happen before, on my friends bikes it doesn't rise over 2 bars due to heat soak. Do something is wrong.

Hey all,So,here's the problem, When I run the bike for 20+ kms at high rpms continuously lets say in the twisties.it runs all fine but once i turn off the key,and turn it back on, themp bar goes all the way upto 11-12 bars and shows high coolant temp,but once I start the bike and let it run for...

Not the best way to do it, you can add a suitable value resistance to the o2 sensor to make ecu to think its running too lean and richen up the mixture a bit.

Ambient temps are around 29degrees Celsius. Bike is running quite normal now.. Will ride for a couple of days and check if low oil pressure issue is present. The low oil pressure dosent come even if im cruising for 100kms at speeds of 100-110kmph. It only used to come if I did high rpm runs...