- Hello rc forum users , im no stranger to bikes i have a few and ive raced sport bikes previously.
Ive recently bought a rc390 new i think there a smart looking bike and after watching them at bsb a couple of years back thought it might make a fun little bike.
its done 35 mile and in bits in the garage im lightening and modifying the bike currently im wanting to fully remove the abs including pump and ecu and wheel reluctor's. But keep the speedo
Regarding the speedo driving from the front wheel my thoughts are to use a speed sensor and disc bolts from a non abs 125 model with same dash ?? my question is does anyone know where the non abs speed sensor plugs in does it go in the loom or in the red spare on the dash? Or is the clock different? And has anyone done this with success ? I can split the pump and just leave the ecu side in place but id like to simplfy the set up too.
Mods so far
Brembo master cyl
Galfer 320mm disc
Wavey rear disc
Pro bolt pre drilled titainium caliper bolts machined down to fit
Sbs pads
venhill custom brake lines
Activ q/a throttle (ment for a yam 300) needs a custom bracket off the throttle body
Loom mod to remove ignition key
Lithium battery
Titainium sprocket nuts
Superspox 44 t rear sprocket
Mods coming soon (week or two)
Titainium swing arm spindle
Titainium wheel spindles
Titainium Spindle pull caps
Titainium captive wheel spacers
New chain
Tyga rear sets
Mods for winter
Enquiried about a larger core custom rad
Samco hoses
Bmc filter
Arrow gp2 ti exhaust
Ohlins shock
Ohlins or adreani fork cartridge kit
Top yoke
51mm clip ons
Tyga carbon bodywork race trim
Pc3 or bazzaz
Quick shifter
Bridgestone rs 10
Hoping they bring out a stroker/bore kit and ive seen a turbo kit but its not ready to market yet thats why im holding out on exhaust.