commandodave
New Member
First i searched the forum for suitable panniers & mounting system for my RC390. I came up blank so I bodged a support system for mounting a set of GIVI Silver soft panniers I had laying about the garage. I don't have welding skills, although I eventually would like to re-fabricate the supports out of 3/8" O.D. tubing. I used a piece of 1-1/2" roof edging that was also laying about the garage. It is made out of tin and easily shaped with a pair of snips. I chose the mounting method i used because it required zero alterations to the frame.
Start with a 23" length of angle. This piece will bolt between the rearmost cap screw of the passenger foot mount and the top bolt of the red side reflector. Drill the two holes. Then mount the flashing between the bracket and the reflector.
photo uploading
img host
The GIVI bags are a universal mount with velco hook and loop taps. Remove the pillion seat. I ran the front strap under the plastic bottom half of the pillion, then under the frame rail. You might have to loosen the bottom plastic to insert the strap under it, then re-tighten it. The GIVI bags had a D-ring front and rear. I drilled two matching holes in the flashing and secured the bottom of the bags to the flashing through the D-rings.
image hosting no register
photo upload sites
When I re-fabricate the mounts I will paint them either black or orange depending on the material. Round tube would definitely be orange! The GIVI bags look slightly out of scale for the RC390. If you have to buy a set, you may want to go slightly smaller for looks. But then you are giving up capacity.
I would like to figure out a way to raise the location where the rear of the flashing mounts to the reflector. I would like to have the top of the bag follow the seat line for esthetics.
Start with a 23" length of angle. This piece will bolt between the rearmost cap screw of the passenger foot mount and the top bolt of the red side reflector. Drill the two holes. Then mount the flashing between the bracket and the reflector.
photo uploading
img host
The GIVI bags are a universal mount with velco hook and loop taps. Remove the pillion seat. I ran the front strap under the plastic bottom half of the pillion, then under the frame rail. You might have to loosen the bottom plastic to insert the strap under it, then re-tighten it. The GIVI bags had a D-ring front and rear. I drilled two matching holes in the flashing and secured the bottom of the bags to the flashing through the D-rings.
image hosting no register
photo upload sites
When I re-fabricate the mounts I will paint them either black or orange depending on the material. Round tube would definitely be orange! The GIVI bags look slightly out of scale for the RC390. If you have to buy a set, you may want to go slightly smaller for looks. But then you are giving up capacity.
I would like to figure out a way to raise the location where the rear of the flashing mounts to the reflector. I would like to have the top of the bag follow the seat line for esthetics.
Last edited: