KodakMoment
Member
2018 RC390 is having some stalling issues in two circumstances. I understand this to be a common problem, but there are no resolutions (apart from one I've listed below) OR people just forget to reply with their resolution.
Brand new bike, less than 100 miles.
Two separate issues:
1. Within the first 10 miles, when downshifting into first gear the engine stalled. It did this several times as I rode the bike home, including on the freeway when I downshifted to lane split. Each time it started back up.
-- I cleaned the side stand sensor and magnet and added a washer in as spacer.
2. When idling and with slight revving, the engine stalled. Didn't matter if it was cold or warm.
-- Unclear on this.
Yes, I'm aware I can take it to a dealer. I still would like to get an idea about what's happening.
I've experienced issues where the engine would die during the first few hundred miles on other new bikes I've owned and over time it stopped. I attributed this to the ECU, but it only happened once or twice (not nearly as consistent as what I'm experiencing now).
Thoughts.. ?
Brand new bike, less than 100 miles.
Two separate issues:
1. Within the first 10 miles, when downshifting into first gear the engine stalled. It did this several times as I rode the bike home, including on the freeway when I downshifted to lane split. Each time it started back up.
-- I cleaned the side stand sensor and magnet and added a washer in as spacer.
2. When idling and with slight revving, the engine stalled. Didn't matter if it was cold or warm.
-- Unclear on this.
Yes, I'm aware I can take it to a dealer. I still would like to get an idea about what's happening.
I've experienced issues where the engine would die during the first few hundred miles on other new bikes I've owned and over time it stopped. I attributed this to the ECU, but it only happened once or twice (not nearly as consistent as what I'm experiencing now).
Thoughts.. ?