Dead Display, bike won't come on

[btalont]

I was working to try and install a Bazzaz fuel module, now the bike is dead. The dash won't come on. Only running lights and turn signals/horn. Anyone run into this? Is there a reset if you pull the battery?

 

[Ryanthegreat1]

Is your kill switch in the run position?

 

[Diploman]

Check your fuse box. If you have one or more melted fuses that would suggest that you inadvertently created a short circuit while installing the Bazzaz. You should always disconnect the negative terminal of your battery when doing any electrical work on the bike. Replace the burnt fuse(es), reconnect the battery and turn the key to "on". If the fuses hold, then you are fine. If one or more blows again, then you have an electrical problem to sort out.