Xquzme
New Member
Hello Fellow RC'ers, I am fighting with a 2016 KTM 390 RC. Just did all the required maintenance for the 15000 km's on out bike. Set the valves as they were all quite tight. All are set now to within the spec range and tried to be on the bottom end of the tolerance. One exhaust is in the top of the range but I couldn't get a shim that would keep it within range so I had to set it at the top end.
Did fuel filter, air filter, oil and filter and new spark plug. I did gap it to spec. Cleaned the throttle body, injector and map sensor. With proper cleaner and compressed.
The bike starts cold no issue. Runs out fine with lots of power and no hesitation. However, once the bike is up to temp it will not start. It tries but stumbles.
Anyone ever experience this. If so what did you do to resolve. I am trying not to go to the dealer if at all possible.
Thanks
Todd
Did fuel filter, air filter, oil and filter and new spark plug. I did gap it to spec. Cleaned the throttle body, injector and map sensor. With proper cleaner and compressed.
The bike starts cold no issue. Runs out fine with lots of power and no hesitation. However, once the bike is up to temp it will not start. It tries but stumbles.
Anyone ever experience this. If so what did you do to resolve. I am trying not to go to the dealer if at all possible.
Thanks
Todd