Nightmare RC390

[KwicK To Master KTM]

Hi All,
Did anyone have any success in solving this issue?
I have had a few issues with My Superduke 990 in the earlier days, very similar.
Now these are all fixed but it took a bit of effort.
I am not sure that the same will apply to the 390's but for the 990 I found a good dyno tuner and used the Tuneboy software (others available) problem fixed.
Please note there is a little known trick that needs to be done after every tune.


Start the bike and let it idle for at least 20 mins which resets the ECU to the new tune.
Do not touch the throttle or any control and if possible put the bike on a paddock stand.
As I said I don't know if this applies to the new 390's but being KTM I would suspect it will.
Good luck.

aP

Hey there aPs- Rod from the Sunshine Coast here ! Yes problem was solved with a PCV from Chad at KTM performance from this forum. I know there are some guys that had luck with the Bazz- az but the idle issue went away instantly with the PCV installed
and a pre - made map by Chad.