Hi all !
I'm planning to buy the WBC2 but i'm a bit confused :
Here's what i don't understand , on the first page we can read :
( NOTE: The Low Voltage output.... is NOT part of the PowerCommander software Map you see on the computer screen. You cannot adjust the low voltage settings on the Software. It can ONLY be changed using a LCD200 .. at this time.. )
And on another thread of this forum we can see people who set target AFR values for the closing loop section (0-80 cells).
As far as i understand the low voltage output does control the closed loop, or do i'm wrong ?
@Ia02 : I'm also planning to get the Bazzaz O2 stabilizer, i'm a 2017+ also and i would really appreciate your feedback on it !
I'm planning to buy the WBC2 but i'm a bit confused :
Here's what i don't understand , on the first page we can read :
( NOTE: The Low Voltage output.... is NOT part of the PowerCommander software Map you see on the computer screen. You cannot adjust the low voltage settings on the Software. It can ONLY be changed using a LCD200 .. at this time.. )
And on another thread of this forum we can see people who set target AFR values for the closing loop section (0-80 cells).
As far as i understand the low voltage output does control the closed loop, or do i'm wrong ?
@Ia02 : I'm also planning to get the Bazzaz O2 stabilizer, i'm a 2017+ also and i would really appreciate your feedback on it !