I wish I had never taken my bike into the dealership to have the valves done ,, why they would leave one valve tight is beyond me...
Anyway screw it I am going to woman up and do that last valve adjustment myself :mad: ..... I have ordered the shims Hotcams ,, should be here today tomorrow ...
head gasket failed on the rc dealer said when i bought it that if i had it serviced with them even though they knew i was going to track it they would honour warranty, i had the ecu flashed by them as i put a pipe and air filter on it 60 mile later the bike almost doesnt start and then over...
b
Im just checking the plug which I think is used to Flash the ECU with the Akra map which im getting done in a couple of days and noticed a brown/blue wire loop inserted in the end?
Im the second owner. Is this normal for stock or has something been done by the previous owner?
Hi guys , ive got hold of the diagnosgic connector for the ktm and a tune boy lead , i was going to download tune ecu software but it doesnt list the 390 and suggests for pre can models only , has anyone had any success pulling a software file/ read from there 390 ecu? , would be nice to get a...
For racing purpose, max torque/power is of course a key parameter, and piggyback ECU as PCV, GET, Powertronic, Bazzaz is good for us.
For road usage, we are not interested only in full load, but also partial load.
Removing the calatyst converter, we don't care anymore to be at lambda 1, and we...
The specifications of KTM RC 390 specify engine power as 43 bhp (approx 32 kW) @ 9000 RPM.
1) This power is available at the Engine Flywheel or at the end of the Transmission Shaft?
2) If I want to tune the ECU and measure performance, how much should be the power measuring capacity of the...
Hello, it's me again.
My dealer said he can't legally tell me how to do it but he said it's easy.
On the cup bike, to get max HP he said he can have his tech reflash the ECU, about 1hr labor, $125
But I would need to take apart the throttle assembly to remove the throttle stop so I can twist all...
I've decided to swallow my pride, and just ask what might be perceived as a "dumb question"..... What is "flashing" an ECU, and what does it do? I used to have a Husqvarna SMR450R that I replaced the stock ECU with the "race" ECU matched to the Arrow dual exhaust I had on it. I honestly don't...
Long awaited post. Sorry for the delay. The Yoshimura is a good alternative option to the Akrapovic system. Each have their pros and cons. Will be discussing each along the way.
First set of data. The blue line is bone stock average blue. The green line is only installing the yosh system, and...
air
blue
ecu
filter
front
horsepower
insignificant
larger
leaner
lid/snorkel
line
loss
makes
map
peak
power
resulting
retaining
rev
slight
stock
system
wouldve
yosh
yoshimura
.
So now that the PCV is installed. it was time to install the Dyno Jet Wideband Commander 2 ( WBC2 or WB2) p.n. 15-7023x........ so we could have more Control over the Fuel map on the bike.
As many of you know the KTM 390 has a difficult ECU that doesn't allow closed loop to be altered...
a/f
autotune
band
bike
closed
commander
conjunction
control
ecu
fuel
ktm 390 wb2 installation
loop
low
map
output
pcv
power
ratio
sensor
voltage
wb2
wbc2
wide
wideband
wire
So I am looking at a winter project on my wife's RC390 doing a werkes exhaust and PCV from Hardracing. However, all my bikes get an ecu flash first to remove restrictions etc. Does this bike need it? I hit 111mph before the governor bumped back down to 109mph. There was more rpms to go before...
Used PowerTRONIC ECU. $225 + free shipping in US. (New is $280 + $65 shipping from India)
KTM::Product page
KTM Duke RC 390This ECU is completely programmable, and comes pre-mapped with optimal calibration for stock and mildly modified vehicles that increases power, efficiency, top speed and...
Hey everyone, I'm new to the site. I just recently got a RC390 and I'm looking to upgrade and I would like your advice!!
1. Muffler - I want the traditional look so am thinking the GPR Ghost is the way to go?
2. Intake - K&M intake?
3. Ecu - Power Commander?
Is this a good mix? I'm new to...
Didn't know where to post this, but if anyone is interested
Selling my PowerTronics piggy back ecu. Comes in box, with all cables and software. Also have a few maps for whoever buys it. Works great nothing wrong with it. The raised rev limit is great, and the software is fairly easy to use...
I've been researching building a DIY O2/Lambda sensor eliminator and came across the following for the Super Duke:
http://www.superduke.net/forum/viewtopic.php?t=8258
A O2 eliminator should trick the ECU into thinking it is in stoichiometric and break the closed loop cycle. This is useful on...
I concur about getting off topic and was think same thing, so....
I will list the sensors from the duke schematic which everybody says is the same just different component locations.
BTW where do you race at?
The following is not really a specific question, just sharing knowledge/experience for others getting their RC390 race ready, specifically in CA:
I was looking into getting the KTM Hard Parts Akrapovic exhaust and the dealer here in CA is refusing to sell me the exhaust (even though this will...